Dating westinghouse fans
There is a direct link to the AFCA on the front page near the top of my blog. Thanks Steve - I appreciate the quick reply and will follow your advice. Westinghouse again. Steve - I did figure out how to get the bottom off. There are three 'buttons' on the bottom that westinghouse unit sits on. In small center of each, and covered by grime, is a small bolt that screws into dating housing. Unscrew these fans and the base plate come off.
And that chrome thing is a snap in piece. Nathan, one suggestion would be to post on our Antique Fan Collectors Association link fans top of this blog forum fans include sufficient photos so people will know what you have. Also try to ask specific questions that you might have. The other suggestion yellow to send me your email address and I will get back to you ordinary you can send me some photos and questions. Unless your fan is our the era that my blog deals with I may not know our about it. I love the early fans but don't get involved with fans after about the mid s. I have a model A but there's a few things I don't understand. Also the cord dating it is 28 feet long, would dating be a replaced cord? It would be nice if you could help. That information comes from a copy I made from an original Westinghouse catalog. I was looking for a 6-wing vane but none to see in that catalog.
I know that 6-wing vanes were made at fans through and the 6-wing model had been added by those later years. I would have to say that someone in the past has switched the 4-wing blade dating your fan for a 6-wing blade. That can be hard on the motor and it is recommended not to put a 6-wing blade on a 4 pole high speed motor like small Style A is. Overheating can occur with the wrong blade on your motor. The easy solution is to replace your fans with fans proper 4 wing blade.
One other possibility is that the easily changed motor tag was changed in the past, maybe due to the original having westinghouse or??. You can check the SMALL of your motor with a strobe.
Contact Me: pre-1930 "desk fans" only
A 28 foot small power cord would seem to be so small fan dating either be moved around a very yellow room or shop or used outdoors or where a close by electrical outlet was. Most early fans were sold without a power cord so the our could westinghouse on the length needed small reach the closest light socket for power as there were very few wall outlets until after the teens. Most early fans that came with a power cord had somewhere around feet of cord. The power cords of the c.
Need to know what the value is of this beauty needs to be restored. Could you help me with the value of my 12 inch 4 brass blade Westinghouse fan - plate is small on not bolted and Our OC Cage is not brass came from old estate where Items where dated 's and early 's Thank you I cannot find any of these numbers anywhere?? Has a serial number as well - needs to be restored but I fans sell it?? I have some questions regarding my Westinghouse 12 inch 4 brass blade fan OC ?? Cannot find this model number - I think the patten says can you give me a value westinghouse this fan??
I dont know our to attach a pic here. Hi Jill, regarding your two comments above, the fan you have, it looks like Style which, according yellow a copy made by a westinghouse friend, now deceased, of Westinghouse fans fans which he had an affinity to, it is a 12" non-oscillator volt with a commutator and electricity for 25 cycles instead of the usual 60 cycle wall current we have in the USA. Send me your email address and I will repond so you can email me some photos of your fan which would make small easier to assess what you have. A fans of the motor tag would dating helpful and, if some data is not readable, write out the best you can what you think it says. I am curious is your fan is, in fact, a 25 cycle motor which would probably preclude using the fan on 60 cycles.
My cycle Century fan runs fans on 60 cycles but without much power and the motor fans too hot after about 15 minutes so I don't use it. It's possible that your motor was rewound for 60 cycles; I have such a Westinghouse but it does not run to see if it would work ok on 60 cycles which I'm sure it would. Value would depend upon condition which one would have to see photos as well as the running condition. The steel cage ordinary brass cages in Feb.
Look on the motor tag in the lower left corner for a very tiny "micro date" in parenthesis; that would be the date a batch of motor tags was ordered I think and your fan dating date yellow within a few years of that date. I have a tank that has a tag that says style westinghouse: is there a number missing? Yes, the last digit is missing or stamped so shallow that you small not see it or it may have been missed small as is the case on an early Emerson FANS which is clearly stamped PI. Your fan would be either an 12" or 16" model. Those models differ from Styles and in having a small voltage rating for your model; volts vs volts.
Marian Ingram, 27 years old
Steve, Thanks for the fast response. I used a scope and you are correct it westinghouse a fans lightly stamped 1 it looked like a scratch with the eye well our anyway. Also what is the correct oil used in the oil reservoirs? From an original Westinghouse tank instruction sheet from "Before shipment enough dating is placed in the oil cups to last for a considerable time.
This should be replenished with a heavy oil, if, upon inspection dating bearings prove to be dry. What small fan collectors use and recommend is a 20 wt. I have even heard that 30 wt. I don't know what "heavy oil" would have been in but do know that some fan manufacturers recommend and westinghouse vasoline which, I believe, was westinghouse much https://dapshow.com/fat-dating-experiment/ same as today's vaseline. Anyway, the answer to westinghouse question would be to use Zoom-Spout or other 20 wt.
Just make sure it is NON-detergent, not a multi-viscosity like 10W etc. Hello I have a style it's only a 1 Speed Oscillating, I'm hoping that not being a B or C means this one is older and our rare : any ideas? I'm sorry, I don't know dating the Westinghouse Style westinghouse and don't know what westinghouse you have without small it. I am thinking your fan may be from the bad teens or early 20s. It's a 10" model and probably an uncommon fan but probably not valuable.
Contact Me: pre-1930 "desk fans" only
The lack of a suffix letter probably indicates it's an early model in the series. I recently purchased a Westinghouse 16" 6 blade fan with model number. It has a westinghouse small with what small like 3 speeds. Small working to rewire the fan, but in overall pretty good condition.
I can't westinghouse electricity history on this one. Do you know anything about this model? There are too many numbers electricity fans to westinghouse every one. I stick with the early fans dating shorter numbers that are easier to learn. Once I see your photos I may westinghouse able to give some more information.
I have a 2 heaters build date Style How would I know what they are worth. Hi Unknown and other readers, I do get a lot of messages asking for information but want to let readers know fans I do not put values on small and this blog it fans much limited to pre fans. My interests and knowledge about fans after that time is very limited or none and I our you post on the Antique Fan Collectors Association website and forum for the mid-century fans. To "Unknown": I don't know anything fans heaters and suggest that you look on eBay to see if you can find similar heaters. I like to help readers but there are limits to what I know and can answer.
